is it posible that since i didnt replace the smart key and the steering lock module at the same time that it has scrambled data between the modules now that cannot be syncd again?Įngine switch cannot be turned on (IG) more than 10 times. i tried the manual vehicle entry and failed again to register key. so at first i just replaced the smart key (certification ecu)which i did now have good communication and was able to ck for codes ect in this module) then after trying to program key unsuccessfully i then replaced the steering lock ecu (all new factory Totota parts) still unable to redigester keys keeps saying failed i get one beep then the bar graf on (autel im 508) gets to the end (no 2nd beep) and says failed i tried another unlocked refirbished key same thing, here is the toyota hint below i tried because i did with techstreem because i did go over the 10 times with key on. I also talked to a very creditable source (programmer, eprom instructor for one of the big key suppliers techsupport) that there was no need to replace the steering lock ecu. Register new keys on a all keys lost situation which when I got to vehice had no comunication with certification ecu(smart key) so after looking at Toyotas publications doc id#RM…VFQ7 on pages 3 and 4 says to replace certification ecu and steering lock ecu, following is the register “A” steps in this publication….
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |